- Appliances
- Washing machines
EF0
AEG EF0 on a washer: leak, excess foam or load issue
Risk level
Medium
Proceed carefully and stop if the check is unclear.
Urgency
Medium
Quick answer
On an AEG washer, EF0 (also EFo, EF3 or 15 beeps) usually comes from a leak, too much foam or an unbalanced load. If you see heavy foam, switch it off and let it settle for a few hours, then check the filter and seal.
Safety first
Stop and check this first
- If water comes out from under the washer, unplug it and turn off the tap before drying the floor or touching the filter.
Safe checks you can perform
- Foam in the drum
- Lint filter
- Detergent drawer
Leave these tasks to a qualified professional
- Do not attempt this professional task: Tracing the internal leak
- Do not attempt this professional task: Full check programme
What a technician must be able to justify
Technician visit
These are the steps they must carry out and show you. Tick them as they work: if steps are skipped, do not accept a part swap.
These are not instructions for opening or handling the equipment yourself. They are the checks that should support a technical conclusion.
Tracing the internal leak
What they doThe technician opens the machine, empties the base and finds the leak point with the washer running: internal hoses, seal, pump and drawer.
They must show youthe leak point found.
In writingthe leak origin, the part replaced with its part number and the reason.
Full check programme
What they doAfter the repair, the technician runs a programme with the correct detergent dose and checks it finishes without EF0 or water underneath.
They must show youthe programme finished without EF0 and the base dry.
In writingthe test carried out, the result and the date.
Before accepting a part or repair
Nothing has been shown yet. Do not accept a part swap based on the code alone.
Follow these steps
Note: Follow the documented order. An error code identifies the affected system, but it does not prove by itself which part has failed.
Foam in the drum
- Who:
- you.
- How:
- look for foam in the drum or drawer; if there is some, switch the machine off and leave it for a few hours until it settles, and use less detergent next time.
- Result that matters:
- whether EF0 came from foam.
- If there was heavy foam and, once settled, the next wash with less detergent ends without EF0:
- it was the foam.
- If there was no foam or EF0 returns:
- go on to the filter.
- Evidence to keep:
- photo of the foam and a note of the dose used.
Evidence: Error EF0, EF3 en lavadora: causas y cómo solucionarlo
Lint filter
- Who:
- you, with the washer unplugged and a tray and cloth underneath.
- How:
- open the filter flap, remove the filter carefully, clean it, look for cracks or a damaged seal and refit it fully tightened.
- Result that matters:
- ruling out a leak at the filter.
- If the filter was loose or dirty:
- once refitted, run a programme and check the front stays dry.
- If the filter is damaged:
- do not use it like that; order the part or call the service.
- Evidence to keep:
- photo of the filter and of the area after the test wash.
Evidence: Error EF0, EF3 en lavadora: causas y cómo solucionarlo
Detergent drawer
- Who:
- you.
- How:
- pull out the drawer, clean it and the sprinkler in its housing, and remove any limescale.
- Result that matters:
- ruling out water spilling from the drawer.
- If it was dirty or scaled:
- after cleaning, wash and check whether EF0 clears.
- If it was clean:
- check the door seal and the inlet hose as for E30 and, if it continues, call the service.
- Evidence to keep:
- photo of the drawer before and after.
Evidence: Error EF0, EF3 en lavadora: causas y cómo solucionarlo
Still not solved
If the error persists, stop here. See what the technician must do and show you.
Where this code applies
A code is meaningful only inside the right product and version context.
Primary scope
- System
- Appliances
- Brand
- AEG
- Product type
- Washing machines
Known code variants
- AEG lavadora EF0
- AEG lavadora EF3
- AEG washer 15 beeps
- AEG washer EF0
- AEG washer EF3
- AEG washing machine error EF0
- EF0
- EF3
- EFO
- Electrolux EF0 lavadora
- Electrolux EF3 lavadora
- Electrolux EF3 washer
- Electrolux washer 15 beeps
- Electrolux washer error EF0
- Electrolux washer leak EF0
- Electrolux washing machine EF0
- error EF0 lavadora AEG
- error EF0 lavadora Electrolux
- lavadora AEG 15 pitidos
- lavadora Electrolux 15 pitidos
- lavadora Electrolux fuga de agua EF0
What it means
AEG Spain says the most common causes of EF0 are water leaks, excess foam and an unbalanced load. AEG UK adds that EF3 is a detected leak that triggers an automatic safety mode, and that if the cause is one of these, the message clears when the programme ends or the next one starts. The washer monitors water outside the tub and how the wash behaves; the code does not say whether water escapes from the filter, the seal, the drawer or an internal part.
Warnings and stop conditions
- Mediumeditorial warning
If water comes out from under the washer, unplug it and turn off the tap before drying the floor or touching the filter.
Evidence: Error EF0, EF3 en lavadora: causas y cómo solucionarlo
Symptoms and causes
Probable causes · in order
- Too much detergent and foamCommon
Heavy foam visible in the drum or drawer after the wash; it settles if you leave the machine off for a few hours.
Evidence: Error EF0, EF3 en lavadora: causas y cómo solucionarlo
- Leak at the lint filterPossible
A filter not fully closed or damaged drips at the lower front; you see water at the foot of the filter.
Evidence: Error EF0, EF3 en lavadora: causas y cómo solucionarlo
- Dirty or scaled detergent drawerPossible
A blocked drawer or sprinkler spills water inside; you see dirt or limescale when you pull it out.
Evidence: Error EF0, EF3 en lavadora: causas y cómo solucionarlo
- Internal or door seal leakPossible
If foam, filter and drawer are fine and EF0 returns, the leak is in the seal, the inlet hose or inside the machine.
Evidence: Error EF0, EF3 en lavadora: causas y cómo solucionarlo · Washing machine displays error message EF0, EFo, EF3 or emits 15 beeps / 15 flashes
Virtual technician
Does EF0 still appear after these checks?
Answer a few questions to narrow down the likely cause and the safest next action. Guidance only - it never replaces a professional.
Sources and technical references
- 1
Error EF0, EF3 en lavadora: causas y cómo solucionarlo
AEG (Electrolux Group) · official_doc
- 2
Washing machine displays error message EF0, EFo, EF3 or emits 15 beeps / 15 flashes
AEG (Electrolux Group) · official_doc
Was this entry useful?