- Appliances
- Personal care devices
Plug reminder flashing
Braun Plug reminder flashing on Series 9 shaver: charge
Risk level
Low
Usually safe to check without specialist tools.
Urgency
Low
Quick answer
The plug icon on your Braun Series 9 is blinking: slowly means about 5 minutes of shaving are left on the battery, quickly means the shaver can only run without a cord. Disconnect it from the power supply before you press the power button.
Safety first
Stop and check this first
- Do not open the housing or try to replace the built-in battery, and do not borrow another supply: Braun limits both to its authorised service and to the supply provided.
- Never rinse the shaver while it is plugged in: the manual allows shower and bathtub use only cordless and detached from the power supply.
Safe checks you can perform
- Disconnect the shaver and switch it on cordless
- Look for the lock icon and unlock the shaver
- Give charging time, the right temperature and a firmly seated plug
Leave these tasks to a qualified professional
- Do not attempt this professional task: Check that the supply matches your shaver
- Do not attempt this professional task: Shaver inspection at a Braun service centre
What a technician must be able to justify
Technician visit
These are the steps they must carry out and show you. Tick them as they work: if steps are skipped, do not accept a part swap.
These are not instructions for opening or handling the equipment yourself. They are the checks that should support a technical conclusion.
Check that the supply matches your shaver
What they doThe technician verifies that the supply is the one delivered with the appliance, or a Braun 492 if the appliance carries that marking, and that it seats in the socket.
They must show youthe marking on the supply and its full seating in the shaver socket.
In writingthe type of supply tested and the outcome of the charge test that follows.
Shaver inspection at a Braun service centre
What they doIf the warning persists after charging with the original supply within the stated temperature range, an authorised Braun service centre checks the shaver and its supply.
They must show youthe icon blinking with the original supply attached after a complete charge of more than 1 hour.
In writingthe diagnosis, whether any part is replaced and whether the repair falls under the 2 year guarantee in the manual.
Before accepting a part or repair
Nothing has been shown yet. Do not accept a part swap based on the code alone.
Follow these steps
Note: Follow the documented order. An error code identifies the affected system, but it does not prove by itself which part has failed.
Disconnect the shaver and switch it on cordless
- Who:
- you, holding the dry shaver.
- How:
- pull the power supply out of the shaver socket or the charging stand and press the on / off button once. Braun asks you to detach the appliance from the power supply before turning it on.
- Result that matters:
- the plug icon no longer fast flashing and the motor starting without a cord.
- If it runs cordless:
- the warning came from using it plugged in; charge the battery with the shaver switched off and use it disconnected.
- If it will not run even cordless:
- check the travel lock in the next test.
- Evidence to keep:
- a photo of the blinking icon and a note of whether the power supply was attached at that moment.
Evidence: Braun Series 9 type 5793 instruction manual (90897614, edition IX-19) · Braun Series 9 type 5793 instruction manual (91112176, edition I-20)
Look for the lock icon and unlock the shaver
- Who:
- you.
- How:
- look for the travel lock icon on the display. In the edition IX-19 manual you unlock by holding the on / off button for 5 seconds; in the edition I-20 manual for the same type 5793 it is 3 seconds. A beep and the icon disappearing confirm the change.
- Result that matters:
- the lock icon gone and the motor answering when you press the button.
- If the icon disappears and the shaver starts:
- it was locked, not broken.
- If there is no lock icon and it still will not start:
- move on to the charging check.
- Evidence to keep:
- a photo of the display with and without the lock and the seconds you held the button.
Evidence: Braun Series 9 type 5793 instruction manual (90897614, edition IX-19) · Braun Series 9 type 5793 instruction manual (91112176, edition I-20)
Give charging time, the right temperature and a firmly seated plug
- Who:
- you, with the shaver charging in a mild bathroom or bedroom.
- How:
- attach the supplied power supply until it snaps in, between 5 °C and 35 °C. A full charge takes 1 hour; the first charge should last at least 1 hour without a break, and the display may need a few minutes to light up once connected.
- Result that matters:
- status segments appearing and no fast flashing once the cable is removed.
- If the display lights up after some minutes:
- it was a delayed start, which the manual describes for appliances stored for long.
- If no response after more than 1 hour:
- do not open the appliance and go to the Braun service centre.
- Evidence to keep:
- the connection time, the rough room temperature and a photo of the display after charging.
Evidence: Braun Series 9 type 5793 instruction manual (90897614, edition IX-19)
Still not solved
If the error persists, stop here. See what the technician must do and show you.
Where this code applies
A code is meaningful only inside the right product and version context.
Primary scope
- System
- Appliances
- Brand
- Braun
- Product type
- Personal care devices
Known code variants
- Braun afeitadora no enciende enchufada
- Braun enchufe parpadea
- Braun Series 9 parpadeo rápido
- Braun Series 9 plug symbol blinking
- Braun shaver will not start while plugged in
- Plug reminder
- Plug reminder fast flashing
- Plug reminder flashing
- Recordatorio de carga
- Recordatorio de carga parpadeo rápido
What it means
In the instruction manual of the Braun Series 9 shaver (type 5793, edition IX-19) the plug reminder is a display icon with two states. Flashing: the battery is low, for example with 5 minutes of shaving time left. Fast flashing: the appliance can only be operated cordless and must be disconnected from the power supply before it is switched on. Other Braun models may show different icons, and the icon alone does not prove that the battery, the power supply or the shaver is faulty.
Warnings and stop conditions
- Mediumsource verified
Do not open the housing or try to replace the built-in battery, and do not borrow another supply: Braun limits both to its authorised service and to the supply provided.
Evidence: Braun Series 9 type 5793 instruction manual (90897614, edition IX-19)
- Lowsource verified
Never rinse the shaver while it is plugged in: the manual allows shower and bathtub use only cordless and detached from the power supply.
Evidence: Braun Series 9 type 5793 instruction manual (90897614, edition IX-19)
Symptoms and causes
Probable causes · in order
- Battery close to emptyCommon
Braun's manual describes the slow blinking of the reminder as low charge, with roughly 5 minutes of shaving time still available at that moment.
Evidence: Braun Series 9 type 5793 instruction manual (90897614, edition IX-19)
- Power supply still attached when switching onCommon
Braun explains that fast flashing means cordless operation only, so pressing the button with the shaver still plugged in triggers that warning.
Evidence: Braun Series 9 type 5793 instruction manual (90897614, edition IX-19) · Braun Series 9 type 5793 instruction manual (91112176, edition I-20)
- Travel lock switched onPossible
The trouble-shooting table lists two reasons for a shaver that will not start: cordless-only operation and an active travel lock, shown as a lock icon on the display.
Evidence: Braun Series 9 type 5793 instruction manual (90897614, edition IX-19)
- Slow charging from temperature or a loose plugPossible
Per the manual, charging may start late after long storage, should take place between 5 °C and 35 °C and needs the power supply to snap fully into the shaver socket.
Evidence: Braun Series 9 type 5793 instruction manual (90897614, edition IX-19)
Virtual technician
Does Plug reminder flashing still appear after these checks?
Answer a few questions to narrow down the likely cause and the safest next action. Guidance only - it never replaces a professional.
Sources and technical references
- 1
Braun Series 9 type 5793 instruction manual (90897614, edition IX-19)
Braun · 2019 · official_doc
- 2
Braun Series 9 type 5793 instruction manual (91112176, edition I-20)
Braun · 2020 · official_doc
Was this entry useful?