- Appliances
- Dryers
E60
Electrolux E60 on a dryer: heating problem
Risk level
Medium
Proceed carefully and stop if the check is unclear.
Urgency
Medium
Quick answer
On an Electrolux tumble dryer, E60 means a heating problem and the laundry does not warm up. Check it is not shut in a cabinet without ventilation, ventilate the room and clean the filters, condenser and door seal.
Safety first
Stop and check this first
- Do not open the dryer to look at the heating element or the heat pump circuit: there is mains voltage and, on heat pump models, refrigerant. That is the service's job.
Safe checks you can perform
- Installation and ventilation
- Filters, condenser and seal
- 30 minute heat test
Leave these tasks to a qualified professional
- Do not attempt this professional task: Heat source diagnosis
- Do not attempt this professional task: Test drying cycle after the repair
What a technician must be able to justify
Technician visit
These are the steps they must carry out and show you. Tick them as they work: if steps are skipped, do not accept a part swap.
These are not instructions for opening or handling the equipment yourself. They are the checks that should support a technical conclusion.
Heat source diagnosis
What they doThe technician checks the heat source: on condenser dryers, the heating element and its protections with a multimeter; on heat pump dryers, the compressor and refrigerant circuit with their instruments.
They must show youthe values measured against Electrolux's specification and the failing part.
In writingthe cause, the part replaced with its part number and the reason.
Test drying cycle after the repair
What they doTo finish, the technician runs a drying cycle and checks the inside warms up and E60 does not return.
They must show youthe cycle running with heat and no E60.
In writingthe test carried out, the result and the date.
Before accepting a part or repair
Nothing has been shown yet. Do not accept a part swap based on the code alone.
Follow these steps
Note: Follow the documented order. An error code identifies the affected system, but it does not prove by itself which part has failed.
Installation and ventilation
- Who:
- you.
- How:
- check the dryer is not inside a closed cabinet without ventilation and that the room is roughly more than 10 to 12 m2; open a window or door while drying.
- Result that matters:
- ruling out warm air having nowhere to go.
- If it was enclosed or the room is small and closed:
- fix the ventilation and try another drying cycle.
- If the installation is correct:
- go on to cleaning.
- Evidence to keep:
- photo of the installed dryer and the space.
Evidence: La secadora muestra el mensaje de error E60 y no calienta · Tumble dryer displays error message E60 and does not heat up
Filters, condenser and seal
- Who:
- you, with the dryer unplugged.
- How:
- clean the lint filters, the condenser and the door seal as the manual describes.
- Result that matters:
- ruling out lint slowing the air.
- If there was a lot of lint:
- after cleaning, run a drying cycle and see whether E60 clears.
- If they were clean:
- do the heat test.
- Evidence to keep:
- photo of the filters and condenser before cleaning.
Evidence: La secadora muestra el mensaje de error E60 y no calienta · Tumble dryer displays error message E60 and does not heat up
30 minute heat test
- Who:
- you.
- How:
- start the time drying programme and, after approximately 30 minutes, check whether the inside is warm.
- Result that matters:
- whether the dryer heats.
- If the inside is warm:
- the dryer heats; if E60 returns, note when it appears.
- If the inside is still cold:
- contact an authorised service centre.
- Evidence to keep:
- note of the time and what you felt.
Evidence: Tumble dryer displays error message E60 and does not heat up
Still not solved
If the error persists, stop here. See what the technician must do and show you.
Where this code applies
A code is meaningful only inside the right product and version context.
Primary scope
- System
- Appliances
- Brand
- Electrolux
- Product type
- Dryers
Known code variants
- AEG asciugatrice E60
- AEG dryer E60
- AEG E60 error
- AEG Fehler E60
- AEG secadora E60
- AEG sèche-linge E60
- AEG Trockner E60
- code erreur AEG E60
- E 60
- E60 AEG asciugatrice
- E60 AEG dryer
- E60 AEG secadora
- E60 AEG sèche-linge
- E60 AEG Trockner
- Electrolux dryer E60
- Electrolux dryer E60 not heating
- Electrolux secadora E60
- Electrolux tumble dryer error E60
- error AEG E60
- error E60 secadora Electrolux
- errore AEG E60
- secadora Electrolux E60 no calienta
What it means
Electrolux defines E60 as a heating problem; the UK page calls it a heating source problem. It applies to condenser and heat pump dryers (and, in the UK, vented ones). The dryer monitors whether it reaches the expected temperature; an unventilated installation, a small room or dirty filters and condenser stop air circulating and trigger the warning. If all of that is fine, the heat source may be broken. E60 does not say which part has failed.
Warnings and stop conditions
- Mediumeditorial warning
Do not open the dryer to look at the heating element or the heat pump circuit: there is mains voltage and, on heat pump models, refrigerant. That is the service's job.
Evidence: Tumble dryer displays error message E60 and does not heat up
Symptoms and causes
Probable causes · in order
- Dryer shut in without ventilationPossible
Electrolux warns it must not be installed in a closed cabinet without ventilation; you see it from how it is fitted.
Evidence: La secadora muestra el mensaje de error E60 y no calienta · Tumble dryer displays error message E60 and does not heat up
- Small or poorly ventilated roomPossible
Electrolux asks for a room of roughly more than 10 to 12 m2 and ventilation by opening a window or door while drying.
Evidence: La secadora muestra el mensaje de error E60 y no calienta
- Dirty filters, condenser or sealCommon
Built-up lint slows the air; you see it when you take out and check the filters and condenser.
Evidence: La secadora muestra el mensaje de error E60 y no calienta · Tumble dryer displays error message E60 and does not heat up
- Heat source faultPossible
If installation and cleaning are fine and the inside is still cold in the 30 minute test, the heat source may be broken.
Evidence: Tumble dryer displays error message E60 and does not heat up
Virtual technician
Does E60 still appear after these checks?
Answer a few questions to narrow down the likely cause and the safest next action. Guidance only - it never replaces a professional.
Sources and technical references
- 1
La secadora muestra el mensaje de error E60 y no calienta
Electrolux · official_doc
- 2
Tumble dryer displays error message E60 and does not heat up
Electrolux · official_doc
Was this entry useful?