- Garden
- Robot lawnmower
1130
STIHL 1130 on iMOW robot mower: mower stuck or wheels spinning
Risk level
Medium
Proceed carefully and stop if the check is unclear.
Urgency
Medium
Quick answer
The iMOW shows 1130 because it has become stuck or its drive wheels are spinning without grip. Disable it with the STOP button, free it, fix the ground or the wire routing, clean the wheels and confirm with OK.
Safety first
Stop and check this first
- STIHL requires the disabling device to be activated before cleaning, transporting or inspecting the mower, and work near the cutting unit only with protective gloves and extreme care.
- If a safety device on the mower is found to be defective, STIHL says not to operate it and to consult a specialist dealer.
Safe checks you can perform
- Activate the disabling device before freeing it
- Clean the drive wheels
- Fix the spot in the garden where it got stuck
Leave these tasks to a qualified professional
- Do not attempt this professional task: Installation review by a STIHL specialist dealer
- Do not attempt this professional task: Drive check at a STIHL workshop
What a technician must be able to justify
Technician visit
These are the steps they must carry out and show you. Tick them as they work: if steps are skipped, do not accept a part swap.
These are not instructions for opening or handling the equipment yourself. They are the checks that should support a technical conclusion.
Installation review by a STIHL specialist dealer
What they doIf the mower keeps getting stuck after you fix the ground, a STIHL specialist dealer can review the perimeter wire routing and clearances on the plot.
They must show youthe wire sections they propose to move and the clearance measurements they took.
In writingthe changes made to the installation, the hours charged and the condition the mower is left in.
Drive check at a STIHL workshop
What they doIf the wheels turn but the mower will not move even on dry, level ground, the dealer can check the drive and read the stored messages.
They must show youthe list of messages stored in the mower and the drive test they ran.
In writingthe diagnosis, any parts replaced and the warranty applied.
Before accepting a part or repair
Nothing has been shown yet. Do not accept a part swap based on the code alone.
Follow these steps
Note: Follow the documented order. An error code identifies the affected system, but it does not prove by itself which part has failed.
Activate the disabling device before freeing it
- Who:
- you, as soon as 1130 appears on the display.
- How:
- press and hold the red STOP button until the disabling device is active; STIHL requires the mower to be disabled before any cleaning or transport. With the mower disabled, move it carefully out of the spot where it got stuck and set it on level lawn.
- Result that matters:
- the mower held by the disabling device and away from where it got stuck.
- If the mower does not show that it is disabled:
- activate it from the More menu with the Lock iMOW entry.
- If it is disabled and free:
- inspect the spot and the wheels before confirming the message.
- Evidence to keep:
- a photo of the display with the code and of the exact place where it stopped.
Evidence: STIHL iMOW RMI 632 and RMI 632.1 Instruction manual (0478 131 8354 D)
Clean the drive wheels
- Who:
- you, wearing gloves, with the mower disabled.
- How:
- brush or wipe mud and packed grass off the drive wheels. STIHL advises against cleaning under running water or with a pressure washer and asks you not to use aggressive cleaning agents.
- Result that matters:
- wheels with a clean tread that can grip the lawn.
- If the wheels were caked in mud or grass:
- after cleaning, unlock the mower and confirm 1130 with OK.
- If they were clean:
- the likely cause is the ground or the wire routing.
- Evidence to keep:
- a photo of each drive wheel when dirty and another after brushing.
Evidence: STIHL iMOW RMI 632 and RMI 632.1 Instruction manual (0478 131 8354 D)
Fix the spot in the garden where it got stuck
- Who:
- you, checking the ground with the mower out of the way.
- How:
- fill in holes or dips in that area and check whether the perimeter wire passes too close to roots, edging or narrow corners. If the lawn was soaked, consider enabling or adjusting the rain sensor so it does not mow in those conditions.
- Result that matters:
- removing the cause so that 1130 does not return in the same place.
- If you level the ground or move the wire:
- watch the next mowing cycles.
- If it gets stuck in different places for no clear reason:
- consult a STIHL specialist dealer.
- Evidence to keep:
- a sketch marking where the stops repeat and the date of each one.
Evidence: STIHL iMOW RMI 632 and RMI 632.1 Instruction manual (0478 131 8354 D)
Still not solved
If the error persists, stop here. See what the technician must do and show you.
Where this code applies
A code is meaningful only inside the right product and version context.
Primary scope
- System
- Garden
- Brand
- STIHL
- Product type
- Robot lawnmower
Known code variants
- 1130 atascado
- 1130 Está inmovil
- 1130 Stuck
- Free iMOW then press OK
- iMOW 1130
- iMOW stuck message
- Liberar robot cortac. luego pulsar OK
- RMI 632 error 1130
- STIHL 1130
What it means
In the messages chapter of the RMI 632 and RMI 632.1 instruction manual (PDF page 81), message 1130 "Stuck" asks you to free the iMOW and then press OK. The causes STIHL gives are that the robotic mower has become stuck or that the drive wheels are spinning. The remedy is to free it, level out the mowing area or change the perimeter wire routing, clean the drive wheels and prevent operation during rain. The code alone does not prove that any part is faulty.
Warnings and stop conditions
- Highsource verified
STIHL requires the disabling device to be activated before cleaning, transporting or inspecting the mower, and work near the cutting unit only with protective gloves and extreme care.
Evidence: STIHL iMOW RMI 632 and RMI 632.1 Instruction manual (0478 131 8354 D)
- Mediumsource verified
If a safety device on the mower is found to be defective, STIHL says not to operate it and to consult a specialist dealer.
Evidence: STIHL iMOW RMI 632 and RMI 632.1 Instruction manual (0478 131 8354 D)
Symptoms and causes
Probable causes · in order
- Mower caught in a dip or against an obstacleCommon
STIHL notes that the mower can get stuck in holes, depressions or where the perimeter wire runs too close to an obstacle.
Evidence: STIHL iMOW RMI 632 and RMI 632.1 Instruction manual (0478 131 8354 D)
- Drive wheels spinning on wet grassCommon
The manual mentions drive wheels turning without moving the mower and recommends cleaning them and preventing operation in rain through the rain sensor.
Evidence: STIHL iMOW RMI 632 and RMI 632.1 Instruction manual (0478 131 8354 D)
- Wire routing that leads into awkward areasPossible
If the mower always gets stuck in the same place, STIHL suggests rerouting the perimeter wire to leave that area out.
Evidence: STIHL iMOW RMI 632 and RMI 632.1 Instruction manual (0478 131 8354 D)
Virtual technician
Does 1130 still appear after these checks?
Answer a few questions to narrow down the likely cause and the safest next action. Guidance only - it never replaces a professional.
Sources and technical references
- 1
STIHL iMOW RMI 632 and RMI 632.1 Instruction manual (0478 131 8354 D)
STIHL · 2021 · manual
- 2
STIHL iMOW RMI 632 y RMI 632.1 Manual de instrucciones (0478 131 9254 D)
STIHL · 2022 · manual
Was this entry useful?